GG INFINITE: ORDER HERE
The Japanese blogger (Tagimi blog) posted today that there might be parts molding defect suspected in the "E-5" part of the HG 1/144 Gundam Airmaster model kit. We do not yet have an official announcement from Bandai.
Info via Tagimi blog
Contact Info:
http://www.bandai.co.jp/support/caution.html
Bandai Co., Ltd., Shizuoka Consultation Center 〒 420-8681 Shizuoka City, Aoi-ku, Naganuma 500-12
TEL :054-208-7520
(Saturdays, Sundays, and holidays, I except the summer and winter holidays) 10:00 to 16:00 hours weekdays
International customer will need to contact the store you purchased from, or directly contact the distribution source in your area.
first the zeta a1
ReplyDeletenow the airmaster
if this is a another molding defect
bandai must be doing something wrong
Bandai would be like: You had one job!
ReplyDeleteLooking at the manual on Dalong, that doesn't seem to be on the outward-facing side of that part. Does that extra plastic just keep it from fitting in?
ReplyDeleteWow! WTF is up with Bandai and all these defects all of a sudden!?
ReplyDeleteas long as it doesn't hinder the build, transformation, or posing, it shouldn't be a problem.
ReplyDeleteAnother one? Seriously Bandai, whoever is handling the molding should be fired!
ReplyDeleteCalm down guys. You lot are over reacting.
ReplyDeleteWar hammer has more molding defects than a Gunpla model.
So this part goes where? Well, as long as it won't hinder any movements or transformation I'm still ok with it. I'll just have to sand it down or just trim it down little by little with design knife. But seriously, another molding defect?? Ok, if another molding defect again found in other recent releases there are definitely some serious problems going on.
ReplyDelete